oops...

[Bombay994]

Looking through the pics from my engine build I figured I would share one of my biggest Fkups on the project..
First one to post what it is I'm holding and why I was so pissed wins!

http://i271.photobucket.com/albums/jj153/Bombay994/motor%20pics/IMG_2306.jpg

[wagonmafia]

dont tell me but pls say that isnt your clutch fork for the release bearing.(dont know the correct word)

[Bombay994]

dont tell me but pls say that isnt your clutch fork for the release bearing.(dont know the correct word)


Yup.....and you can't get it back in without splitting the motor from trans all over again. It ended up being a very late night

For those that don't know, this fork goes on the throwout bearing on the clutch and is responsible for disengaging it, without it the clutch is pretty much useless

[Robk0000]

Weight reduction, you dont need that anyways. lol

[Nate8409]

I think it is a triCK!

He must have upgraded to WRC concentric style release bearing. No forks or slave cylinder.

Slave and release are all one unit.

[Bombay994]

I think it is a triCK!

He must have upgraded to WRC concentric style release bearing. No forks or slave cylinder.

Slave and release are all one unit.


Nope, I actually am that stupid, if you look real close at the pic you can see the slave, and the rubber boot that is supposed to have the fork sticking out of it.....:(

[Bu11dogg2]

That's like forgetting to refill your blinker fluid!